How to check material certificates and batch traceability
Agree the inspection documents before ordering and match each delivered item or package to its own heat or lot and test results.
Specify the document package before ordering
State the product specification and edition, grade, form, dimensions and delivery condition. If the order requires an EN 10204 inspection document, name the exact type, such as 3.1 or 3.2, in the purchase order and confirm who must validate it. For powder, agree which batch COA results are required, such as particle size distribution with its measurement method. Record any separate dimensional report or third-party inspection requirement.
Match the certificate to the physical delivery
Start with the purchase order line and check the certificate issuer, grade, product form, specification, condition and heat or lot identifier. Match that identifier to the item marking, coil label or sealed package and its packing list. Review each heat or lot separately if the shipment contains more than one. For cut pieces, ask how the marked stock was linked to each piece or package.
Compare reported results with the applicable acceptance limits and units. Check that dimensions, test conditions and specimen details are included where the specification or order calls for them. A typical value on a datasheet describes reference performance, while the inspection document reports results tied to the material supplied.
Resolve gaps before accepting or using the material
If a marking is missing, the identifier differs, or a required result is absent, record the purchase order line, certificate reference and label or marking photo. Set aside the affected material until the supplier can reconcile the identity or provide the required document. Keep the approved record with the receiving inspection and any material split or relabeling records.
Hợp kim đặc chủng và vật liệu hàn